BPDMP - PDL 328 B COMPONENT

Product Identification

Product ID:PDL 328 B COMPONENT
MSDS Date:11/08/1990
FSC:8030
NIIN:00N030052
Kit Part:Y
MSDS Number: BPDMP

Responsible Party
POLYMER DEVELOPMENT LABS INC
212 W TAFT AVE
ORANGE, CA 92665
US

Emergency Phone: 714-921-2300

Info Phone: 714-921-2300

Preparer: EZZAT SEIF

Cage: 1N060

Contractor
POLYMER DEVELOPMENT LABORATORIES INC
ORANGE, CA 92665-4220 US

Telephone: 714-921-2300

Cage: 1N060

Ingredients

HYDROXYL TERMINATED POLY(OXYALKYLENE) POLYETHER

Fraction By Weight: 96%


TERIARY AMINE BEARING COMPOUNDS

Fraction By Weight: < 2%


COVER AS MUCH EXPOS SKIN AS POSS W/APPROP

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:LD50: (ORAL,RAT) >5000 MG/KG
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL: MAY CAUSE IRRIT TO THE THROAT
AND RESPIRATORY PASSAGES BUT AT ROOM TEMPERATURE, VAPOR INHALATION
IS NOT CONSIDERED HAZARDOUS. SKIN: THIS PRODUCT CONTAINS AMINE
CATALYST AND WILL CAUSE IRRIT TO THE SKIN AFTER PROLONGED CONTACT.
SOME INDIVIDUALS MAY BE MORE SENSITIVE TO EXPOSURE. INGEST: THIS
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: IS NOT CONSIDERED A COMMON
OCCUPATIONAL ROUTE OF EXPOSURE, AND NO OBSERVABLE EFFECTS HAVE BEEN
DEMONSTRATED.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYE:FLUSH W/CLEAN, LUKE-WARM H*2O @ LOW PRESS FOR @ LST 15
MIN, OCCASNLY LIFTING LIDS. SEE MD IMMED. SKIN:REMOVE CONTAM CLTHG.
WASH EXPOS AREA W/WARM SOAPY H*2O THORO. CONTAM CLTHG SHOULD BE
PROPERLY LAUNDERED BEFORE REUSING. INHAL:NOT CONSIDERED HAZARDOUS
IN AN INDUST SITUATION. REMOVE TO FRESH AIR. SUPPORT BRTHG (GIVE
O*2/ARTF RESP). INGEST:INDUCE VOMIT. NEVER GIVE ANYTHING TO
(SUPDAT)

Fire Fighting

Flash Point Method:PMCC
Flash Point:248F,120C
Extinguishing Media:DRY CHEM, EXTING SUCH AS MONOAMMONIUM PHOSPHATE,
POTASSIUM SULFATE, POTASSIUM CHLORIDE. ADDITIONALLY, CO*2, (SUPP
DATA)
Fire Fighting Procedures:DO NOT DIRECT SOLID H*2O STREAM/FOAM INTO HOT,
BURNING POOLS; THIS MAY CAUSE FROTHING & INCR FIRE INTENSITY. USE
NIOSH/MSHA APPRVD SCBA & FULL PROT (SUPP DATA)
Unusual Fire/Explosion Hazard:NONE.

Accidental Release

Spill Release Procedures:CNTN THE SPILLED MATL & THEN COVER W/A LOOSE
ABSORBENT MATL SUCH AS OILDRY, VERMICULITE, SAWDUST/FULLER'S EARTH.
SHOVEL WASTE MATL INTO PROPER WASTE CNTNRS. WASH THE CONTAMINATED
AREAS WITH HOT SOAP W ATER THOROUGHLY. VENT AREA TO REMOVE VAPORS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STOR TEMP 65F-75F. AVG SHELF LIFE IS 6
MOS FROM DATE OF MFG. IF CONTAM W/ISOCYANATES IS SUSPECTED, DO NOT
RE-SEAL CNTNR BECAUSE OF POSS (SUPP DATA)
Other Precautions:ALWAYS SLOWLY VENT CONTAINER WHEN OPENING TO RELIEVE
ANY PRESSURE BUILDUP. THIS PRODUCT IS HYDROSCOPIC. CONTAINERS
SHOULD BE TIGHLY SEALED TO PREVENT MOISTURE CONTAMINATION. DO NOT
EXPOSE TO HIGH TEMP ERATURES FOR ANY LENGTH OF TIME.

Exposure Controls

Respiratory Protection:IT IS HIGHLY RECOMMENDED THAT A NIOSH/MSHA
APPROVED AIR PURIFYING RESPIRATOR WITH ORGANIC FILTER CARTRIDGES BE
WORN. IN ADDITION, IN ANY SPRAY APPLICATION, A NIOSH/MSHA APPROVED
SUPPLIED AIR SOURCE MU ST BE PROVIDED.
Ventilation:NATURAL/MECH. LOC EXHST WILL KEEP TLV BELOW MIN IN MOST
CASES. SPILLS OR OTHER EMERGENCIES MAY REQUIRE MORE (SUPP DATA)
Protective Gloves:CHEM RESISTANT:NATURAL RUBBER/PVA.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FSHLD .
Other Protective Equipment:SAFETY SHOWERS & EYE WASH STATIONS SHOULD BE
PROVIDED IN ALL WORK AREAS. ALL EMPLOYEES SHLD BE PROPERLY TRAINED.
(ING 3)
Work Hygienic Practices:NO CONTACT LENSES SHOULD BE WORN.
Supplemental Safety and Health
EXTING MEDIA:HIGH EXPANSION (PROTEINIC) CHEM FOAM, H*2O SPRAY FOR LRG
FIRES.FIRE FIGHT PROC:EQUIP. BURNING CAN PRODUCE CO*X & NITROGEN.
VENT:FORCEFUL VENT MEANS. FIRST AID PROC:DRINK OR INDUCE V OMIT IN
AN UNCON PERSON. NOTE TO MD:BASICALLY, TREATMENT IS
SYMPTOMATIC.HNDLG & STOR PREC: RUPTURE DUE TO PRESS BUILDUP.

Chemical Properties

Boiling Pt:B.P. Text:DECOMPOSES
Melt/Freeze Pt:M.P/F.P Text:<32F,<0C
Vapor Pres:NIL
Vapor Density:> 1.0
Spec Gravity:1.07
Solubility in Water:SLIGHTLY SOLUBLE
Appearance and Odor:CLEAR TO AMBER VISCOUS LIQUID, SLIGHT AMMONIA ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH ISOCYANATES AND OTHER SUBSTANCES THAT REACT WITH
HYDROXYL GROUPS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:ALIPHATIC FRAGMENTS, CO, NH*3, CO*2.

Disposal

Waste Disposal Methods:WASTE MATERIAL MAY BE INCINERATED OR DISPOSED OF
UNDER LOCAL, STATE AND FEDERAL REGULATIONS CONTROLLING
ENVIRONMENTAL PROTECTION.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.